EFEKTIFITAS VASRIASI PUTARAN DARI PROSES BALANCING TERHADAP PUTARAN KERJA POROS YANG SESUNGGUHNYA

Djoko Sulistyono, Arief Budiman

Abstract


Balancing the goal is to balance the machine or the rotating shaft, which in turn will reduce the vibration.
Balancing is done pasa shaft-disk system by responding vibration in five rounds variations balancing: 400 rpm,
600rpm, 800rpm, 1000 rpm, 1200 rpm. Retrieval of data by performing the balancing process which further
balancing process that responds to vibrations to determine the mass of unbalancenya and a counterweight on the
shaft angle disc. Results balancing is then rotated in the other rounds to determine the effectiveness of balancing has
been done to change round. The purpose of this test is to get round the balancing effective. The test results showed
that the balancing process is able to reduce the vibration conducted properly, this indicates that balancing is done
on a round shaft below the critical round-the dish is less effective. In addition, the balancing is done on rotation
away from a critical lap is relatively effective. While balancing is done on a round close with a round of critics is
relatively effective. Balancing process that is performed in the round balancing is far from critical rotation has
advantages over balancing the work done at the round when viewed in terms of security while balancing process is
done

Keywords: balancing, spindle disc, critical round


References


Abidin, Zainal., 1996, Vibration Monitoring

Balancing/Alignment, LPM-ITB,Bandung.

Abidin, Zainal., 2007, Mailig List

Dimaragonas, Andrew D., Sam Haddad., 1992,

Vibration for Enginners, Prentice Hall International

Inc., Englewood Cliffts, New Jersey

Holowenko, A.R., 1980, Dinamika Permesinan,

Erlangga, Jakarta.

Spigel, L., and Limburnner, G.F., 1991, Applied

Static and Strength of Materials, Maxwell

Macmillan Canada. Inc.

Efektifitas Variasi Putaran Dari Proses Balancing Terhadap Putaran Kerja Poros Yang Sesungguhnya

(Djoko Sulistiono Dan Arief Budiman)

Structures/Motion Lab. 20-263-571, section 001,

, 003, Hewlet Packard, 2003.

Tim Getaran Mekanis., 2002, Panduan Praktikum

Fenomena Dasar Mesin, sub Getaran Mekanis,

modul III. Balancing Empat Putaran (Four-run

balancing), Jurusan Teknim Mesin Fakultas Teknik

Universitas Sebelas Maret, Surakarta.

Wowk, Voctor., 1995, Machinery Vibration,

Balancing, McGraw-Hill Inc, New York


Refbacks

  • There are currently no refbacks.