PENGUKURAN PANJANG PLASTIK ROL BERBASIS MIKROKONTROLLER AT Mega 8535
Abstract
The development of a microcontroller system in the control system more advanced, more and enable people to perform the control of a device automatically without a computer device. This makes the control systems in various industries increasingly easy and cheap. In this study will be made of plastic cutting machine control system roll sensor-based optocoupler. This tool uses two dc motors, one as a driver to roll up the plastic so that the plastic to form a roll (a roll), and other dc motor to move the heater (seal) and cutter. For the heating process (seals) used a wire niklin while cutting process using a saw blade. Untukmenentukan long pieces of plastic then used an optocoupler sensor and microcontroller ATmega16 as the main control center.
Kata kunci : Mikrokontroller AT Mega 8535
Downloads
References
Andrianto Heri, “Pemrograman Mikrokontroler AVR ATMega16 menggunakan bahasa Câ€, Bandung, Indonesia : Penerbit Informatika, 2008.
http://repository.usu.ac.id/handle/123456789/28677. Diakses 29/4/2014 08:55
http://www.datasheetcatalog.com/datasheets_pdf/A/T/M/E/ATMEGA16.shtml. html.
Diakses 07/05/2014 05:20
http://eprints.undip.ac.id/20735/1/kendali_motor_dc_sebagai_penggerak_mekanik.pdf. Diakses 9/5/2014 14:50
Sumanto, 1984. Mesin Arus Searah: Generator dan Motor DC. Andi Offset:Yogyakarta.
http://elektronika-dasar.web.id/teori-elektronika/motor-servo/ Diakses 11:15 10/5/2014
http://guru-indonesia.net/admin/file/f_9346_mikrokontrl.pdf Diakses 5/15/2014 10:55
Authors who publish with Heuristic agree to the following terms:
- Authors transfer the copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.. that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access)